Hi i am begginer both arduino & labview programing . I wanna make a school project on labview graph interface and i bought arduino yun for wi-fi .
When i try to upload the LIFA_base.ino
Arduino: 1.5.5-r2 (Windows 8), Board: "Arduino Yún"
AFMotor.cpp:97:5: error: #error "This chip is not supported!"
AFMotor.cpp:114:5: error: #error "This chip is not supported!"
AFMotor.cpp:134:5: error: #error "This chip is not supported!"
AFMotor.cpp:152:5: error: #error "This chip is not supported!"
AFMotor.cpp:173:5: error: #error "This chip is not supported!"
AFMotor.cpp:190:5: error: #error "This chip is not supported!"
AFMotor.cpp:213:5: error: #error "This chip is not supported!"
AFMotor.cpp:230:5: error: #error "This chip is not supported!"
AFMotor.cpp: In constructor 'AF_Stepper::AF_Stepper(uint16_t, uint8_t)':
AFMotor.cpp:334: error: 'CS20' was not declared in this scope
This report would have more information with
"Show verbose output during compilation"
enabled in File > Preferences.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.