How To: display a message during for loop, with no user input necessary

[DSRTM]

Hi jmcbee, I only have labview 8.5 installed, could you please resave in that version?  I have to get 8.6 installed by our IS people......

thanks

Darren

---

jmcbee wrote:
Take a look at the attached VI's.  They will display a popup busy display with a programmable title.  The start and stop busy signal is sent using an Action Engine.  In you code you would remove the wait ms timer with error function and replace that with your 1 iteration for loop.  Let me know if you have any questions.

---

[jon_mcbee · Accepted solution]

Here you go.  Take a look at the Example.vi

[DSRTM]

Like I said, I'm new to LV

it works nicely when I copy my For Loop into your code, but not when I put your code into my VI.  I'll check it out and report back.  Thanks for the help so far, I really appreciate it. 

Darren

---

jmcbee wrote:
Here you go.  Take a look at the Example.vi

---

[DSRTM]

---

jmcbee wrote:
Here you go.  Take a look at the Example.vi

---

Allright!  Done, works and seems to perform nicely.  Thanks everyone for the input.  Hopefully one day I can be the solution, not the question in this forum.

I have more Q's I'll start another thread when I get to it......has to do with saving files and error proofing.

Thanks again jmcbee.

Darren

[Ben]

---

DSRTM wrote:

...  Hopefully one day I can be the solution, not the question in this forum.

I have more Q's I'll start another thread when I get to it......has to do with saving files and error proofing.

Thanks again jmcbee.

Darren

---

"From your post to God's ears"

We can always tolerate more help.

Ben