回复： Labview ECU MC Examples Running Error(error-301096)

[阿莲]

Hello All, I'm running  the example "Edit a parameter curve.vi" always appear "Error-301096" without a real ECU, Error: A timeout occurred while waiting for a response from a slave device.

• My hardware communication tool is "USB-8501".

• My Labview software version is "LabVIEW Runtime 2018 SP1 f5".
• My ECU MC Toolkit version is "ECU Measurement and Calibration Toolkit 20.6", also installed "ECU Measurement and Calibration Toolkit Runtime 20.6".
• My NI-XNET version is "NI-XNET 20.5.1"

Before each time run the "Edit a parameter curve.vi", I've already run the "ECUMC Demo ECU XCP.vi", The following picture is detail configuration:

It's only display ECU Running, Then I running the  "Edit a parameter curve.vi", The following keeps happening:

I use "ECUMC XCP and CCP Trace" monitoring  the communication Frame information,  It is observed that only have request frame without response frame, the following picture is detail:

I am troubled by this question,  I appreciate being offered some solutions to the problem.

Thanks!

ALian

New User

[阿莲 · Accepted solution]

     Problem solved.

The ECU MC Examples Running simulation need config Protocol: TCP/IP, Not Protocol: CAN ,               Follow the link below:

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000YGumCAG&l=zh-CN

ALian

New User

[donbosco100]

Can i run Ni Xnet frame transmissions and ECUM simultaneously.

[ZYOng]

Please start a new thread for a new question.

Anyway, see Run ECU MC or ADCS and XNET Simultaneously On the Same CAN Port

[donbosco100]

I have tried it, and it's giving an Error. Please share any solution.

[ZYOng]

The baud rate settings must be the same.

What are the baud rate settings on DBC and A2L files?