Automotive and Embedded Networks

cancel
Showing results for 
Search instead for 
Did you mean: 

Labview ECU MC Examples Running Error(error-301096)

Solved!
Go to solution

Hello All, I'm running  the example "Edit a parameter curve.vi" always appear "Error-301096" without a real ECU, Error: A timeout occurred while waiting for a response from a slave device.

    

  • My hardware communication tool is "USB-8501".

  • My Labview software version is "LabVIEW Runtime 2018 SP1 f5".
  • My ECU MC Toolkit version is "ECU Measurement and Calibration Toolkit 20.6", also installed "ECU Measurement and Calibration Toolkit Runtime 20.6".
  • My NI-XNET version is "NI-XNET 20.5.1"

Before each time run the "Edit a parameter curve.vi", I've already run the "ECUMC Demo ECU XCP.vi", The following picture is detail configuration:

 

ECUMC demo ECU XCP.png

 

It's only display ECU Running, Then I running the  "Edit a parameter curve.vi", The following keeps happening:

 

error.png

 

I use "ECUMC XCP and CCP Trace" monitoring  the communication Frame information,  It is observed that only have request frame without response frame, the following picture is detail:

 

Trace.png

 

I am troubled by this question,  I appreciate being offered some solutions to the problem.

Thanks!

 

ALian

New User

 

0 Kudos
Message 1 of 8
(2,740 Views)
Solution
Accepted by topic author 阿莲

     Problem solved.

The ECU MC Examples Running simulation need config Protocol: TCP/IP, Not Protocol: CAN ,               Follow the link below:

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000YGumCAG&l=zh-CN

 

ALian

New User

0 Kudos
Message 2 of 8
(2,715 Views)

Can i run Ni Xnet frame transmissions and ECUM simultaneously.

0 Kudos
Message 3 of 8
(1,420 Views)

Please start a new thread for a new question.

Anyway, see Run ECU MC or ADCS and XNET Simultaneously On the Same CAN Port

0 Kudos
Message 4 of 8
(1,416 Views)

I have tried it, and it's giving an Error. Please share any solution.

donbosco100_0-1697479301533.pngdonbosco100_1-1697479342270.png

 

0 Kudos
Message 5 of 8
(1,407 Views)

The baud rate settings must be the same.

What are the baud rate settings on DBC and A2L files?

0 Kudos
Message 6 of 8
(1,399 Views)

Baud Rate the same as 500k If run parallel ECUMC and xnet it s gives error

donbosco100_0-1697514155831.png

 

donbosco100_1-1697514317555.png

 

0 Kudos
Message 7 of 8
(1,386 Views)

The ECUMC Demo ECU XCP runs on CAN 2.0, but your DBC is running CAN FD+BRS.

0 Kudos
Message 8 of 8
(1,368 Views)