From 11:00 PM CST Friday, Feb 14th - 6:30 PM CST Saturday, Feb 15th, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

time slot problem

Solved!
Go to solution

 Hi,

I am stuck with a problem.  I have to assign timing to the task for load prioritization . If my grid supply gets OFF, during 08:00 Hr to 20:00 Hour then my diesel generator should get ON for Load A and if my grid supply gets OFF after 20:00 Hour till morning 8:00 hour of next day the same diesel generator should get ON for Load B. this turning ON of diesel generator should have delay of at least 2 minutes. should i use timed loop or sequence, if yes please tell me how?

0 Kudos
Message 1 of 22
(3,968 Views)

@nehaom wrote:

should i use timed loop or sequence


Try a state manchine.

0 Kudos
Message 2 of 22
(3,961 Views)
Hey Thanks!! I am just developing logic, does state machine require interfacing?
0 Kudos
Message 3 of 22
(3,954 Views)

@nehaom wrote:
Hey Thanks!! I am just developing logic, does state machine require interfacing?

I don't understand the question. What do you mean by "Logic"? by "interfacing"?

 

0 Kudos
Message 4 of 22
(3,946 Views)

By interface, I mean does it will require DAQ asst. to check grid supply and system timing to ckeck time? And By Logic I mean, I am just writing prog in Labview.

0 Kudos
Message 5 of 22
(3,935 Views)

how would I give time. i am able to introduce wait, I took current date time and add a wait to current time, to introduce delay, but i m not getting how to assign timing? Please help me.. i m stucked here since last 7 - 8 days.

0 Kudos
Message 6 of 22
(3,933 Views)