I am trying to make cRIO-9022 work with LabVIEW 2015 sp1 installed on Windows 7. I can see my cRIO under the remote system but the status shows disconnected. I tried to reboot the cRIO and restart the computer ( basically followed the solution in https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000P70YSAS&l=en-GB ). Then I restarted the system in safe-mode and reset the IP address (followed the instruction in 'Troubleshoot Remote System Discovery'). However, the status still shows disconnected. Any suggestions for this issue?