08-08-2012 09:03 AM
I am trying to calibrate a NI 9211 unit but I keep getting the following error code.
Error or termination occurred. This calibration may not be valid. Error code: -200081 Error message: Error -200081 occurred at DAQmx Start Task.vi at step Verify Analog Input:1 Number of Channels: 2 Sample Rate: 7.140001 Maximum Sample Rate: 6.000000
I am using CalExec version 3.3.2. Is there a fix to this problem?
Ryan A. Saunders
Idaho National Laboratory
Standards and Calibration Lab
phone: (208)526-2202
email: Ryan.saunders@INL.gov
08-08-2012 10:36 AM
Hi Saipanman,
Which DAQ Chassis are you using??
Are you are using a single Module Carrier such as a NI USB-9162 or are you using a cDAQ chassis such as the NI cDAQ-9172?
08-08-2012 11:55 AM
The user has it in a NI USB-9162
08-09-2012 02:57 AM
Hi Saipanman,
Calibration is only possible will a Chassis such as the 9172 as this is not available for the single module carrier such as the 9162.
If you are able to, try using a Chassis to perform the calibration instead.
08-09-2012 12:41 PM