LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Unable to send DIO siganl using LabVIEW FPGA Module and MyRIO

Solved!
Go to solution

Everything works when no FPGA is used. So the harware and circuit are working. 

However when targeting FPGA module on MyRIO, the data acquisition and processing works and the signal to the motors is "sent" (visible when Hightlight Execution is enabled).  But there is no voltage on the DIO ports used. The FPGA projects includes VHDL code.  

 

Do you know what might cause this problem? 

 

 

 

0 Kudos
Message 1 of 2
(2,614 Views)
Solution
Accepted by aan928

You have to control the DIO through the FPGA.


GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
0 Kudos
Message 2 of 2
(2,608 Views)