Timing is off

[Geologian]

I am certain there is a simple solution but I haven't written a VI in several years. Attached is a snippet of code that calls on a sensor connected via 485. I am struggling to control the frequency of measurement. I would like to be able to tell it to read data 10 ms, 100 ms, or 1000 ms, etc. but at the moment I can't seem to control it. Any thoughts?

Thank you.

[Gregory · Accepted solution]

It looks like you are reading from 2 separate channels? The "Wait (ms)" you are using has the effect

Start For Loop

Wait X ms

Read Channel 1

Wait X ms

Read Channel 2

Exit For Loop

[Geologian]

Can you dumb that down for me? I don't know how to break the 2 channels into separate reads as you describe. Thanks.

[Gregory]

I think you already are doing 2 reads by using the For loop

[Geologian]

I was totally overthinking this. Thanks.