Smart lighting control system using labview and arduino

[MishZ]

Hi,I am a new engineer and working on a project of home automation using labview and arduino.I want to control the turning on and off of bulb and lamps in my house model when it sense a movement any movement (smart lighting system) and control the on off through Labview.I am a new user of LabView.How can I make a block diagram of lighting control system and interface arduino with Labview?

[Ranjeet_Singh]

You need to play with little hardware also. First of all you need to find a solution to interface movement sensor to arduino. This is as per your requirement. I am sure there is lots of option readily available. Google it. Then you can use output of light sensor to turn ON/OFF light using relay.

[MishZ]

Yes will do that.How can I make a front panel in LabView showing on off button and monitoring of the lighting system?

[Ranjeet_Singh]

there is ON/OFF switch to show whether light is on/off in front panel.

What is the output of sensor

[Neos]

please go through these links

LabVIEW Introduction Course - 3 Hours

LabVIEW Introduction Course - 6 Hours

[MishZ]

I haven't completed it.I am stuck with the labview circuit

[Ranjeet_Singh]

What labview circuit?

[MishZ]

oops! block diagram

[Neos]

you are stuck means that you tried somthing. It is better to show us what you tried so far.

and do not ignore the basic courses.

[dkfire]

So what have you done?

Have you taken any of the basic tutorials ?