09-19-2014 09:47 PM
09-19-2014 10:47 PM
You need to play with little hardware also. First of all you need to find a solution to interface movement sensor to arduino. This is as per your requirement. I am sure there is lots of option readily available. Google it. Then you can use output of light sensor to turn ON/OFF light using relay.
09-20-2014 02:46 AM
09-20-2014 04:01 AM - edited 09-20-2014 04:03 AM
there is ON/OFF switch to show whether light is on/off in front panel.
What is the output of sensor
09-20-2014 04:12 AM
please go through these links
LabVIEW Introduction Course - 3 Hours
LabVIEW Introduction Course - 6 Hours
09-20-2014 04:48 AM
09-20-2014 04:50 AM
What labview circuit?
09-20-2014 05:11 AM
09-20-2014 05:27 AM
you are stuck means that you tried somthing. It is better to show us what you tried so far.
and do not ignore the basic courses.
09-20-2014 05:31 AM
So what have you done?
Have you taken any of the basic tutorials ?