02-29-2012 09:09 AM
my colleage has a problem after updating to LV2011 (from 2010) and now get: LabVIEW load error code 3: Could not load front panel
Same on my system (also tried a mass compile)
He's afraid of loosing some of his work ..
Zipped Folder is attached
Solved! Go to Solution.
02-29-2012 09:36 AM - edited 02-29-2012 09:37 AM
02-29-2012 10:05 AM
03-01-2012 04:12 AM - last edited on 01-03-2013 04:55 PM by JordanG
It should work now.
Instructions to fix a corrupted VI in 2011 or higher:
1. Close LabVIEW
2. Add connPaneRecoveryMode=True to the LabVIEW.ini file (-The LabVIEW.ini file is located in the National Instruments folder>>LabVIEW 2011>>LabVIEW.ini)
3. Open the corrupt VI.
4. Push Ctrl+A on the block diagram and the copy and paste to a new VI.
5. Save the new VI.
6. Close LabVIEW and remove the ini token (VERY IMPORTANT)
7. Restart LabVIEW and load the new VI and verify it is correct. Save
03-01-2012 06:27 AM
04-02-2012 07:03 AM
Hello to all,
I have also a vi that return that error. What can I do?
Thanks to all!
04-02-2012 09:19 AM
Can you post it? Which version is ist?
04-02-2012 09:45 AM
You can see the .vi in attach.
04-03-2012 01:30 AM
Here you have it! 🙂
04-03-2012 03:29 AM
But what can I do next time this happens. The only solution is sending to you?
Thanks for your help!