05-30-2018 09:12 AM - edited 05-30-2018 09:13 AM
@Hatemaboud wrote:
ok so now when I upload the LIFA_Base I get an error message says (( this chip is not supported))
LIFA has long since been deprecated and replaced by LINX
Here's a tutorial to get you going. Getting Started with LINX
In this tutorial we'll install LINX, setup a new LINX device and run our first example
05-30-2018 09:26 AM
LINX can be quite a bit easier to use than LIFA ^
(You are currently using LIFA)
05-31-2018 05:45 AM
Thank you so much, now it Works.
but still have a small question; it takes few seconds to start reding the signal from the potentiometer at the begining then when it starts reading it continues well, is that normal or there is something wrong!?
Regards
Hatem
05-31-2018 05:53 AM
Thank you so much, now it Works, but still have a small question; it takes few seconds to start reding the signal from the potentiometer at the begining then when it starts reading it continues well, is that normal or there is something wrong!?
Regards
Hatem
05-31-2018 02:51 PM
It is normal that the setup of communication can take some time.