05-17-2017 10:32 AM
I claim to be a labview neophyte. My situation is as follows: I measure the signal coming from a shift sensor that is read from my control unit; When the signal curve decreases (the sense of motion is reversed) I want to send (through the same control unit) a trigger signal that opens a pneumatic servo valve. Is it possible to do these operations using labview? Thank you.
Solved! Go to Solution.
05-17-2017 11:09 AM
05-18-2017 01:38 AM - edited 05-18-2017 01:39 AM
Thank you very much GerdW for replying. I don't know the hardware DAQ yet. When I will know it I will write back here. I wanted only to know if POTENTIALLY this was possible using labview.
Best wishes,
Pietro.