A trigger in labview

[ptr92]

I claim to be a labview neophyte. My situation is as follows: I measure the signal coming from a shift sensor that is read from my control unit; When the signal curve decreases (the sense of motion is reversed) I want to send (through the same control unit) a trigger signal that opens a pneumatic servo valve. Is it possible to do these operations using labview? Thank you.

[GerdW · Accepted solution]

Yes!

😄

Spoiler

You should clarify which DAQ hardware you are using to get more detailed answers…

[ptr92]

Thank you very much GerdW for replying. I don't know the hardware DAQ yet. When I will know it I will write back here. I wanted only to know if POTENTIALLY this was possible using labview. 

Best wishes,

Pietro.