LabVIEW Interface for Arduino Discussions

cancel
Showing results for 
Search instead for 
Did you mean: 

Arduino - Labview Error 5003

Solved!
Go to solution

thx its work, wonderful

0 Kudos
Message 31 of 37
(1,390 Views)

your fix instructions is too easy and it works well,

Thank you so much.

0 Kudos
Message 32 of 37
(1,323 Views)

What is the solution when using Labview LINX though since LIFA is being replaced with LINX?

 

Error 5003 occurs even when the port is not being occupied in the IDE. One reason I noticed was that aborting the VI vs. stopping causes this error, but there must be other reasons too. Not entirely sure what is the reason. Anybody figure that one out with using LINX firmware? 

 

 

0 Kudos
Message 33 of 37
(1,150 Views)

i am sorry, i did not understood, can you please which value you set with '0' ?

0 Kudos
Message 34 of 37
(570 Views)

Thank you very much,
It helped me a lot now, not sure how in 2023, this error still exists

0 Kudos
Message 35 of 37
(498 Views)

You are a life saver!

Thank you very much 

0 Kudos
Message 36 of 37
(365 Views)

Thank you, this solves it. I had the same issue!

0 Kudos
Message 37 of 37
(11 Views)