Could not stop ARM device!

[desbellons]

Hello!

First excuse me for my poor english... I begin to work with Labview embedded for ARM with the MCB2300 (Labview2010). At the beginning, I worked on I/O and I had no problems. After, I would test TCP/IP connection and web server ; because it was not a succes I worked woth exemples of uvision4.

Now, I could not work ; I have this message with Labview:

[14:23:23] Status: Error
EVALUATION MODE
Running with Code Size Limit: 32K

Could not stop ARM device!
Please check the JTAG cable.
Error: Target DLL has been cancelled. Debugger aborted !

Detail: [UVSC_DBG_ENTER, MSG: 0x2000, STATUS: 0x1] (1)
Status: Run failed.

I have this message if I would work with uvision: "Could not stop arm devices! Please check the JTAG cable."

Thanks

[DavidS.]

Hi,

This link explain that this is a uLink2 error:

http://www.keil.com/support/man/docs/ulink2/ulink2_errors.htm

I think this could be useful for you

Best Regards

PS: vous pouvez poster en français si cela vous arrange.

[desbellons]

Merci pour votre réponse! Le problème est résolu.

Ma réponse pourra peut être servir à d'autres ; j'ai enfin réussi à utiliser Flash Magic. Voici quelques précautions.

 . alimenter la board (ne pas brancher le câble série)

 . dans "Flash Magic" -> Tools Terminal

 . appuyer sur RESET de la board et brancher le câble série en COM0 de la board, relâcher le RESET

=> la board renvoie le message 'Synchronized', on peut maintenant dialoguer par le port série