I have the student version of Multisim 11 and it says it will expired now in 11 days. What do I need to do???

[kewi]

I have the student version of Multisim 11 and it says it will expire now in 11 days. What do I need to do???

[Fernando_D]

Hi,

Did you purchase Multisim? Do you have a Serial Number? The evaluation is good for 30 days. If you have a Serial Number just run the NI Activation Wizard. Open Multisim, on the initial screen click on Activate and follow the steps in the activation wizard.

Fernando

[kewi]

Sir, It was installed correctly, however I have unistalled, and reinstalled it; now I do not get the expiration notice but I still cannot use the wattmeter. Can someone tell what the issue is. Is it the product; like my computer minded brother In law says it is. I have a new DELL and it works fine. Please Reply

[strangelove]

I'm having a similar issue with Multisim 12.0.  When I attempt to run the activation wizard, my serial number is rejected, even though it is exactly the same one that's listed on the NI website for my registered products.

[Fernando_D]

Hello,

For activation issues please contact technical support at ni.com/support

Regards,

[Cqiao13]

Erm..

i don't know how to ask question so i post it here,sorry for disturb.

i'm designing a digital clock circuit.

However, i faced problems during reset part.

when i tried to reset on 3(U11) with 1 NAND gate and 2 NOR gates,
i think i don't make mistake to reset with 0011(U3),how come the 3 will also appear on the seven-segment display?

Well,i also wonder how can i reset  the other seven-segment display(U9) to show the following sequences:
0,1,2,3,4,5,6,7,8,9,0,1,2,3,0,1,2,3,4,5,6,7,8,9,0,1,2,3,0.. 

Lastly, is that possible to configure the transmition speed in multisim 11.0?
 
Thanks.. 

[Tayyab_R]

Please refer to following forum post:

http://forums.ni.com/t5/Circuit-Design-Suite-Multisim/digital-clock-reset-problem-with-74193N/m-p/20...