Cannot find resistance in Multisim for DSDB

[ZoeWang]

Hi all

I am using Multisim 14.1 Education Edition and DSDB and I want to build a circuit according to the this documents in multisim. However, I cannot find components like Resistance,PNP, VCC and so on. How can I fix this problem?

The software list is shown as below:

• LabVIEW2015
• Multisim 14.1 Education Edition.
• National Instruments Digital Systems Development Board
• LabVIEW 2015 SP1 FPGA Module Xilinx Tools Vivado 2014.4

[carmen9]

Hi Zoe,

I am not sure whether this problem is because it is in PLD mode, but usually you will be able to find resistors in the Basic group.

[ZoeWang]

Hi Carmen

Thanks for your reply.

According to the documents I mentioned before, components like tesisrors should exist. So I want to figure out what is wrong with my operation. Thanks again for your help!

Best regards

[carmen9 · Accepted solution]

Hi Zoe,

Just wondering whether your project is created using

1. Open a new blank design.
2. Select Place»New PLD subcircuit

or

1.  In Multisim, select File»New.
2.   Click the PLD Design… the click the Create button.

From this tutorial , when you create a PLD Design, the components shown (PLD mode) is similar to your screenshot.

Best regards,

Carmen

[ZoeWang]

Hi Carmen

Thanks for your reply！I  figured out what went wrong with my operation. ：） There are two mode in the tutorial, and I mixed the Simulation Schematic and the PLD Schematic.

Have a nice day!