Multifunction DAQ

cancel
Showing results for 
Search instead for 
Did you mean: 

DAQCard-6024E Card Fails Self Test - what wrong?

I am attempting to write a Visual C++ application that uses a DACCard-6024E and I have installed the NI-DAQmx 7.4 drivers.  Measurement and Automation Explorer has detected the card as "Dev1".  An I/O port and IRQ were assigned.
 
When I do a "Self-Test", I get the following error message.
 
---------------------------
Error
---------------------------
The device self test has failed.  The error report from the device driver is as follows:
Error -200020 occurred at Self Test

Possible Reason(s):
Self-test of the device has failed.

---------------------------
OK  
---------------------------
Am I missing a step that will enable the board?
 
Thanks.
0 Kudos
Message 1 of 2
(2,764 Views)
Try removing the device from your PC, then uninstall your DAQmx drivers and install DAQmx 8. Shutdown and put the device back in and see if it passes self-test.
--
Michael P
National Instruments
0 Kudos
Message 2 of 2
(2,745 Views)