DAQ to generate variable amplitude 1 kHz Sinewave

[TNeilson]

I am looking for the lowest cost solution to generate a 1 kHz sinewave (this will likely need to be variable as well, but nothing greater than 3 kHz is needed).  I do need the amplitude to be fairly precise though, and have it go as low as 10 mV p-p and as high as 1 V p-p. 

[Laura F.]

Hello TNeilson,

The Low-Cost M Series devices offers 16 bits of resolution and an analog output range of +/-10 V, giving you a code width of about 0.3 mV.  The absolute accuracy is 3.23 microVolts.  You can see this information for yourself in the M Series Help (User Manual and Specifications).  I was looking at the specifications for the PCI-6221.  Our lowest cost options, USB-6008 or 6009, will not work for you because they do not have the ability to do hardware-timed analog output. 

Please let me know if you have any questions about this.

Regards,

Laura

[TNeilson]

I do have a PCI M series card here I'll try out.  I've been using the DAQpad USB stuff for the last year and haven't really needed any analog stuff, and tried it with one of those and could get very good results at all.  In fact, I couldn't put out 1 kHz at all.  Does this seem correct?

[Laura F.]

Hello TNeilson,

This does seem correct.  The DAQPad 6015/6016 specifications say that software timed analog output can go to 300 S/s (system dependent) and hardware timed analog output can go to 50 S/s (system dependent).  You will be much better off with a PCI device for analog output because of the much higher rates.

Regards,

Laura

[TNeilson]

Yes, that does sound right.  I'll test it out with the PCI card and see if I get better results.

Thanks.

[TNeilson]

Well, the card I have is the PCI-6025 and it doesn't seem to be working.  I use the Measurement and Automation explorer and set up a sinewave for 1000 Hz -1 to 1 V and I only get 100 mHz.  Am I setting something up wrong?  I would think this card could at least get faster than that.

[Laura F.]

Hello TNeilson,

Are you using the DAQmx Test Panels?  The frequency of the wave you produce should be 1/1000th of the update rate you specify and it should show in the Frequency indicator.  So with a 1000 Hz update rate, you should get a 1 Hz sine wave.  The specifications for the analog output of this device are:

Max update rate
	DMA 3		10 kHz, system dependent
	Interrupts		1 kHz, system dependent

So I also would think you could go faster than 100 mHz with the test panel.  What programming language are you using?  Perhaps we could try running an example.  Also you could check the functionality of this device using the DAQ Diagnostic Utility (note that you need NI-DAQmx installed). 

Regards,

Laura