02-25-2021 12:07 AM
hello
i am now able to control the motor in open loop
but to make it as closed loop, i have to measure the speed of motor and given as input to controller in labview to control the speed of motor.
kindly help me to measure the speed of motor using Labview and myrio which will be taken as input to controller
04-01-2021 01:04 AM - edited 04-01-2021 01:05 AM
04-08-2021 04:17 AM
thank you sir
in our project hall sensors are used to sense the position of rotor. I want to calculate the speed of motor using hall sensor, using Labview.The output of Hall sensor are given in Lab view. According to that pulses will be generated and given to machine. now i have to calculate the speed from hall sensor.is it possible, kindly let me know sir.
04-11-2021 02:25 PM
Hi,
You will need a device to acquire the analog analog signal from the sensor, like a DAQ module with analog input.
I found an example of how it's implemented, check this link out, hope this helps 🙂
Also see: https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000x0z2CAA&l=ru-AM