while loop not stopping motor

[dg_lbe]

Hello,

  I'm LabVIEW along with NI motion controller software and PCI-7332/UMI 7774 hardware controlling a stepper motor. 

My issue is:

When enc rollover = 5 while loop stops

but with remainder of value from 20 to 500.

Why is remainder not zero.

When test setup indicator is true

the while loop does not stop.

Please view the attached code.

Thanks

[mikeporter · Accepted solution]

The remainder would have to do with what is happening inside the subVI that wasn't included. The output value from it is not stopping at an exact multiple of 4095. The question is why that is so.

Mike...