usb 6211 and LabView - good for IV characteristic aquisition?

[lauraciamma]

Hi there,

I pre-emptively declare my lowest level in using LabView and all the annex tools, so my question won't result too silly.

I need to automatically acquire the IV characteristics for 4 solar devices, so I am thinking about connecting them to the USB 6211 in order to switch from one device to another one.

My question is: can I use a LabView Program in order to simulate the Voltage signal to apply (range c.ca -1 to +1 V), and then collect the relative current?

If so, how??

Many thanks in advance for any sort of help.

Laura

[NIquist]

http://zone.ni.com/devzone/cda/epd/p/id/5918

http://zone.ni.com/devzone/cda/tut/p/id/7229

LabVIEW has a toolkit available for this.  It uses an SMU card but you could simulate that with your 6211 and a current sensing resistor.

[DinosaurBarBQue]

There are no silly questions.

There are just silly moods to feel that so 

[lauraciamma]

---

@NIquist wrote:

http://zone.ni.com/devzone/cda/epd/p/id/5918

http://zone.ni.com/devzone/cda/tut/p/id/7229

LabVIEW has a toolkit available for this.  It uses an SMU card but you could simulate that with your 6211 and a current sensing resistor.

---

Thank you so much for your infos!

[lauraciamma]

---

@DinosaurBarBQue wrote:

There are no silly questions.

There are just silly moods to feel that so 

---

You are right,but you know.. sometimes the doubt is still there..!! Thanks