11-18-2011 12:45 PM
Hi there,
I pre-emptively declare my lowest level in using LabView and all the annex tools, so my question won't result too silly.
I need to automatically acquire the IV characteristics for 4 solar devices, so I am thinking about connecting them to the USB 6211 in order to switch from one device to another one.
My question is: can I use a LabView Program in order to simulate the Voltage signal to apply (range c.ca -1 to +1 V), and then collect the relative current?
If so, how??
Many thanks in advance for any sort of help.
Laura
11-18-2011 02:26 PM
http://zone.ni.com/devzone/cda/epd/p/id/5918
http://zone.ni.com/devzone/cda/tut/p/id/7229
LabVIEW has a toolkit available for this. It uses an SMU card but you could simulate that with your 6211 and a current sensing resistor.
11-19-2011 08:11 PM
There are no silly questions.
There are just silly moods to feel that so
11-19-2011 08:33 PM
@NIquist wrote:
http://zone.ni.com/devzone/cda/epd/p/id/5918
http://zone.ni.com/devzone/cda/tut/p/id/7229
LabVIEW has a toolkit available for this. It uses an SMU card but you could simulate that with your 6211 and a current sensing resistor.
Thank you so much for your infos!
11-19-2011 08:35 PM
@DinosaurBarBQue wrote:
There are no silly questions.
There are just silly moods to feel that so
You are right,but you know.. sometimes the doubt is still there..!! Thanks