need to make a xy plotter using labview

[Ramprakash0111]

i have a vi which has an grayscale edge d now detected image  .now i need to extract the co ordinates of the image and plot the same sequentially in a chart . i have dove it using gcode parsing . but i need to do it with the co ordinates. pls help me

i am working a project to plot the image on a paper. your ideas please !!!!!!!!!!!!! 

i firstly need to plot the image given below in the chart likie it is drawing it..

Thank you

[bseguin]

You image is already a XY coordinate... use pixels.

Benoit

If you interface your Gcode to a XYZ table using a GRBL, use my toolkit:

https://lavag.org/files/file/303-grbl-11/

Benoit

[Ramprakash0111]

so i have to use an arduino interfaced with labview right?

[Ramprakash0111]

fine do u hav any idea on this ? help on generating gcode in labview or any other method to control a cnc machine using labview

[Ramprakash0111]

Can u elaborate on how i shld use ur grbl vi . i currently need to convert the coordinates to gcode so that i can make the grbl read my gcode.

[bseguin]

take a look at that...

https://openbuilds.com/

it is also possible to find free firmware for Arduino if you have all the electronics already.

Alibaba, E-bay is full of low cost kit that allow you to do that.

But what is you real project? university, college or business?

Benoit

[RavensFan]

---

@Ramprakash0111 wrote:

Can u elaborate on how i shld use ur grbl vi . i currently need to convert the coordinates to gcode so that i can make the grbl read my gcode.

---

Please read  A plea for full words

 

Then rewrite your message using English.