01-03-2020 03:52 PM
Hello,
I am working on a labVIEW project that is FPGA mode. Ive been intending to use an i2c LCD with myRIO in FPGA mode, however, i do not know how to get that done. I've tried running the LCD in scan mode without any FPGA related and it works fine, but i cannot seem to know how to start it in FPGA mode.
Thank you,
01-07-2020 03:00 AM - last edited on 04-04-2024 01:18 PM by Content Cleaner
I'm not sure, but I would expect the RIO evaluation board to work the same:
FPGA-RIO-Evaluation-Board-Using-the-LCD-Display
In short, perhaps this is helpful: