LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

load read using Labview not corresponds to that from Bluehill (instron 5565)

VI programm is usd to read load from Instron, however, the load obtained using Labview is calculated on the base of  voltage singal. This caculated value does not equal to the value from Bluehill

 

Download All
0 Kudos
Message 1 of 3
(2,077 Views)

Without seeing your LabVIEW code all I can guess is that you are doing it wrong.

========================
=== Engineer Ambiguously ===
========================
Message 2 of 3
(2,059 Views)

@RTSLVU wrote:

Without seeing your LabVIEW code all I can guess is that you are doing it wrong.


Aaaand. The 8-Ball says, <Drumroll /\/\/\/\\/\> "It is certain."

 

So, what you need to do is:

  1. find out what you are doing wrong
  2. then do it the right way.

Hint: read the manual. most likely causes are:

  1. Calibration not applied or applied incorrectly
  2. cell load not zeroed before measurement
  3. improper conditioning of the analog signal

 

 


"Should be" isn't "Is" -Jay
0 Kudos
Message 3 of 3
(2,055 Views)