am new to lab view. Can someone help me with how to create a small program that lights an LED. The led must be on 10-20seconds and switches off for 60seconds and repeat the process continuously
There are only two ways to tell somebody thanks: Kudos and Marked Solutions Unofficial Forum Rules and Guidelines "Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
Thank you so much for the reply and advise. I went through the whole exercise and it was very helpful. My developed program is as attached and I am using Labview 8.6. My problem is to control the time the LEd remains in the switched on position. I can control the on and off switching of the LED. Can I add another loop for this
Thank you so much for the new code. That is exactly what I was looking for. The only proplem I am having now is to link the code with my DAQ. When I wire the DAQ assistant to replace the LED out side the loop, several error messages are appearing. See attachment.
Change your DAQ assistant to so that it is for a line output rather than a port. A port encompasses multiple lines, and as such, requires a numeric determine the combination of lines to turn on and off.
Thank you a million times for the response and comments. I am still new labview and you might wondering how I am still asking for your advise . I am stil not sure how to change the DAQ assistant to line output. What I have done is on the DAQ assistant, I have clicked it and changed that from port to line out put and then it initialised the VI. However, there is til some a problem with the wiring which shows and error.
