interfacing xbee using labview

zeta_6 · ‎02-09-2012

Hi guys. I just developed a vi to interface xbee module based on the xbee development board.

It seems work fine first. But when I extended the length to more than 5 bytes, only first 5 bytes

can be read.

one more thing: how can I observe the data flow in hex when highlighting the execution? It might

to solve my problem

Thanks!

PhillipBrooks · ‎02-09-2012

@zeta_6 wrote:

how can I observe the data flow in hex when highlighting the execution? It might to solve my problem

You could create a custom probe.

Now is the right time to use %^<%Y-%m-%dT%H:%M:%S%3uZ>T
If you don't hate time zones, you're not a real programmer.
"You are what you don't automate"Inplaceness is synonymous with insidiousness

zeta_6 · ‎02-15-2012

Thanks!

LabVIEW