USB-8506 XNET test

[Zepeda79]

I'm trying to read a LIN sensor, but still don't have any response

I connected DB9 according documentation

• PIN 3 - GND
• PIN 6 - GND
• PIN 7 - LIN
• PIN 9 - 12V

I obtained the ldf file from the supplier in NI-XNET Bus monitor

When i start monitoring, the PORT 1 LED is turned on but there is no response

1st question - In the USB-8506 the "ready" LED should stay in red or green? The documentation i found is not clear about it.

2nd question - Is there something that maybe i'm missing?