Reg DAQ module: Very Urgent

[Madhusudhanan]

Hi,

I would like to ask some queries related to the NI products.
We are going to design one system to measure the movements of throat and abdomen using 3-axis accelerometer. For that, we have 3 ideas to design the same. Out of these, we preferred the NI LabVIEW.

The following parameters to be considered:


To measure the analog signals with the help of 3-axis accelerometer(sensor)
From the o/p of sensor, we will convert the analog signals to acceleration.
After the above, we are going process the above said requirement.


For this, a separate DAQ module is available. I would be very much grateful if you tell me the cost of the module.

Regards,

Madhusudhanan

[shjukheter · Accepted solution]

Hello,

              The movements are detected by accelerometer and it produce the variation as analog output. So, most probably you will get voltage signal as changes to the input variations.

 Currently, I am working with single axis accelerometer and I am acquiring the data with NI USB 6008/6009 quite comfortably. It all depends on your resolution. You can find more details about these DAQ's here

http://digital.ni.com/manuals.nsf/websearch/7781F8E689519ED786257411006FB09F