LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Problem with input reading

Hi guys. I made a .vi that generates an output signal and it reads in input. I could not change in real time, frequency and amplitude, in the sense that changing the values ​​of these two quantities there were not changes. I must press stop and then i set the new values ​​to get the desired changes. This is because I had not added a while loop. At the time that I included the while loop with regard to output it's ok. The problem is reading input. If through two cables i connect the output pins with the input pins of my card daq i can not display the signal that I'm creating and I do not understand where I'm wrong. I'm using LabView from two weeks and i are not very practical. I am sorry for my bad English. Thanks
0 Kudos
Message 1 of 4
(2,395 Views)

Right now you have two tasks running in parallel.

Are they suppose to run sequentially?

0 Kudos
Message 2 of 4
(2,360 Views)

Yes Smiley Happy

0 Kudos
Message 3 of 4
(2,351 Views)

Hi Zlatan,

 

I cannot understand your issue: do you want to change dynamically the signal paramethers during the generation, or do you want to do anything else?

 

Thanks,

have a nice day.

 

FBM

0 Kudos
Message 4 of 4
(2,314 Views)