Please help to automatically print the coordinates on the drawn line

[rhksdn6370]

Hello, if you look at the vi I made, there are lines from (0,0) to various concentric circles, can you make the coordinates of the points that touch the circle automatically come out?

[altenbach]

Can you define the meaning of "come out"?

Sorry, cannot look at your code at the moment. Consider saving for previous (LabVIEW 2020 or below) before attaching.

[paul_a_cardinale]

I looked at your code.

It's very sloppy.

So I stopped looking at it.

[altenbach]

OK, I had a chance to look at your code, and has has been mentioned, it is extremely convoluted.

• The terminals of latch action booleans belong inside their respective frames.
• All your shift registers are equivalent to autoindexing, so simplify! 
• There is an "=0" primitive.
• Your formula node should be replaced by G code. There are many subexpressions that you calculate multiple times.
• There are significantly easier ways to calculate circles.
• Your insert into array are the same as built array(concatenate mode). No need to wire indices.
• You can build your data as complex datatype. No need for dynamic data and express VIs.
• To create gaps in graphs, insert a point with NaN.
• etc.

I have problems with my VM locking up, so please "save for previous (2020 or below)" and attach again.

[alexderjuengere]

---

---

your original .vi is indeed a bit messy, but when I run your .vi, it creates data in a XY Graph.

the following is focusing on that data in the XY Graph, because I think it would be easier to start over again, than to rework your existing code.

---

@rhksdn6370 wrote:

Hello, if you look at the vi I made, there are lines from (0,0) to various concentric circles, can you make the coordinates of the points that touch the circle automatically come out?

---

I assume 

you want this	but the data your .vi creates, looks like this