Noise from Strain Gauge Reading

[askhassan]

Hi, I am trying to get some data from a strain gauge using a quarter bridge setup through NI 9235. I am getting this noise shown in the attached picture. Is it something related to hardware installation? or is it something from the LabVIEW software or the way I setup this? I used DAQassist for the input.

[aeastet]

That is a really close look at your data. Did you happen to notice the scale on the Y axis? You are in the E-6 range.

[askhassan]

Yes, I just want to know if this is normal or if its an acceptable range

[aeastet · Accepted solution]

Yes that would be a pretty clean signal.