Showing results for 
Search instead for 
Did you mean: 

NI Digital Pattern Editor Save Capture for Comparison

Is it possible to save the data that I just captured (potentially in a register), then capture again and compare the two? I want to see if a new measurement matches the last measurement. I can easily do this afterwards in Labview by capturing all the data, but I was wondering if I could utilize the match function. 


-I want to take a measurement (capture), then take another measurement (capture) and check if they are the same. 



0 Kudos
Message 1 of 2

Nope, not from the Digital Pattern Editor. You can do it manually or using LabVIEW / drivers

Soliton Technologies

New to the forum? Please read community guidelines and how to ask smart questions

Only two ways to appreciate someone who spent their free time to reply/answer your question - give them Kudos or mark their reply as the answer/solution.

Finding it hard to source NI hardware? Try NI Trading Post
0 Kudos
Message 2 of 2