LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

NI Digital Pattern Editor Save Capture for Comparison

Is it possible to save the data that I just captured (potentially in a register), then capture again and compare the two? I want to see if a new measurement matches the last measurement. I can easily do this afterwards in Labview by capturing all the data, but I was wondering if I could utilize the match function. 

 

-I want to take a measurement (capture), then take another measurement (capture) and check if they are the same. 

 

Thanks!

0 Kudos
Message 1 of 2
(456 Views)

Nope, not from the Digital Pattern Editor. You can do it manually or using LabVIEW / drivers

Santhosh
Soliton Technologies

New to the forum? Please read community guidelines and how to ask smart questions

Only two ways to appreciate someone who spent their free time to reply/answer your question - give them Kudos or mark their reply as the answer/solution.

Finding it hard to source NI hardware? Try NI Trading Post
0 Kudos
Message 2 of 2
(447 Views)