Master CAN interface using NI-XNET libraries

[aRCo]

Hi all!

In the past i developed successfully an application able to set the CAN interface (termination, transceiver type, baudrate) and to write and read frames using NI-CAN 2.7.2 libraries (see attached files).

Now i would like to reach the same objectives using NI-XNET 1.1.1 libraries. How can i do this?

Please, consider that i succeeded reading and writing but not setting the interface. If possible attach an example with the three phases: setting-opening, writing-reading and closing.

Thanksyou so much!

[Taki1999]

Start Here:

Migrating from NI-CAN to NI-XNET

I've been going through much of the same process and it's been working out pretty well.  Post if you get hung up on any particular part.

[aRCo]

You're right, but don't have enough time to investigate now.

I think that a simple example would be useful for the whole community!

[alex83]

Hi,

In the "find example" there is a project called "NI-XNET CAN session.lvproj" 

The project contains an example session for each read and write session type and a simple VI is provided to test each session.

Alex