Linear Voltage Ramp (Analog)

[Jordan F]

Your program worked for me when I tried it with a valid device name.  I would check the device name in Measurement and Automation Explorer to make sure that it is correct in your program (Simon showed how to do this earlier).  Also, I attached a screenshot of how to disable auto scaling the x-axis so you will have a constant time axis. 

Message Edited by Jordan F on 12-23-2008 12:42 PM

[Siyah]

Thanks all Chris Simon and Jordan.

Theese informations helped me very much.

You all are very kind thanks again.

Wish success at work.

I will pray for you all the time 🙂 

[Siyah]

Hi Everybody its me again 🙂

I have just get my DAQ card it is NI USB-6009 8 Inputs, 14-bit,Multifunction I/O

I have connected and tried the vi the last error (200220) is not occured its ok but there is another error.I have posted it and 

I have posted my MAX window.

Can you help me with this 

Thanx. 

[Dennis_Knutson]

If you look at the specs, you will see that the analog output has a maximum range of 0-5V. You are requesting  -5 to +5.

[Siyah]

Hmm i can see now.My DAQ isn't suitable for -5 +5 range then.

Cant i work my vi with this DAQ?

It does not support negative values?

[Siyah]

Mr Dennis.

Thanks for reply

Now i tried in 0 +5V range but error occures again anyway.

Is it happens because of the +5v -5v values in vi block diagram ? 

Thanks again.

By the way İ changed the block diagram and it works true with 0 +5.

Message Edited by Siyah on 12-24-2008 06:45 AM

Message Edited by Siyah on 12-24-2008 06:48 AM