I am experiencing a problem with the beep.vi. I have a DAQ program, which acquired signal and compare it to a threshold value. When one signal is out of range, a visual and sound alarm occurred. I am using the VI beep.vi to generate the sound.

[Ihab]

I  am experiencing a problem with the beep.vi.  I have a DAQ program, which acquired  signal and compare it to a threshold value. When one signal is out of range, a visual and sound alarm occurred. I am using the VI beep.vi to generate the sound. Everything is working well except the sound alarm. It gives type mismatch 1-D array. I tried to overcome this by putting it in a case structure. But it still doesn't work. could any one help? Please find attached my VI. Best regards to all visitors of NI Discussion Forums.

Ihab El-Sayed

[smercurio_fc · Accepted solution]

reposted here: http://forums.ni.com/t5/LabVIEW/Playing-sound-based-on-exceeding-a-threshold-value-1D-array-data/m-p...

[Ihab]

Thank you for your prompt reply.

I am afraid I found my self put a long text in the question text box. And I thought it might be confusing, therefore i simply decide to put it in a better presentation.

However, your analysis is right. I need to have both audio and visual alarm. My visual is working fine , but I do not know where to place the OR. is the right position after my greater than comparison? or before it? I guess it should be after the greater than comparison?

What about the case structure? you did not mentioned it in your comment? ?? I added type cast to get rid of the broken wire, but it did not succeed in generating voice beeo???

please show me in details where to put the OR?

Thanks

[smercurio_fc]

Please keep the discussion in one place! Put all comments in the other thread.

[Ihab]

Thanks , It was olved by adding an OR array.