Help Build pmw control with accelerator and arduino

[StewKidz]

Hello,

good night,

i am new to labview
pls help me to build a project or give the design,  because im confused how to connect accelertor to PMW with arduino,

This the rules:

Create a program using LabView configuration between the sensor
Accelerometer with the speed of a DC motor is used. Where speed motors
DC will change according to the level of the tilt sensor accelerometer.

Im waiting your aswer,

please share .vi

Thank & Regards,

Stew kidz

[RTSLVU]

If you are asking us to do your homework, you are not going to get very far. 

This is not a school, we don't teach LabVIEW.

You should start by going through the free Linx tutorials at the LabVIEW makers Hub since you are using an Arduino

https://www.labviewmakerhub.com/doku.php?id=libraries:linx:start

And you need to make an attempt to write the program yourself, then come to us and show your code when you get stuck.

[StewKidz]

Hello  RTSLVU,

Thanks you for your solution,

But now im have other problem,

when My accelerator on 0 degree labview read the value 1,6, and when my accelerator on 90 degree the value is 1,9.

And when my accelerator on -90 degree the value is 1,3.

How to convert it to degree??

Regards,

Stewkidz

[SEMAK · Accepted solution]

Hello 

TRY This and Enjoy 😉

[natasftw]

SEMAK, I'm guessing your VI implements a simple y = mx+b function.  In cases like these, it's more helpful to push the poster towards that path than create it for them.  It's the "teaching to fish" story.