Re : Exchange data between 2 chassis using NI PXI 8383mc

[KaiserJJ]

Hello,

I am searching to exange data between 2 chassis using NI PXIe8383mc setup on both chassis:

Configuration:

- 2 PXI chassis

- 2 controller NI Real Time NI PXIe8135 (OS pharlap)

- 2 NI PXI 8383mc

- 1 MXI wire for connecting both NI PXIe8383mc

I search for a while on different National Instrument ressources but I didnt find enough informations:

Does it needs To install additional driver on each chassis?

How do I programmaticaly (labVIEW) exchange data between the 2 chassis?

Is there any example available?

If you have any informations to share, it would be very helpfull.

Thanks

KaiserJJ

[Niki']

Hello KaiserJJ,

I did some research on your configuration. First of all, in order to use your NI PXIe8383mc you have to install the NI-PXImc driver as it is mentionned on the NI page of the card.

>>NI PXIe-8383mc

http://sine.ni.com/nips/cds/view/p/lang/en/nid/211882

Since you are using 2 PXI chassis, I suggest you to install it on both. Here is the link to donwload it:

>>PXIe-8383mc Drivers 1.0:

http://www.ni.com/download/ni-pxie-8383mc-drivers-1.0/4278/en/

Now, concerning the example, I'm pretty sure there will be some help in the driver once it will be installed. I managed to find this white paper, maybe you didn't see it. There is no example but there is this small third part about the software driver:

"The NI-PXImc driver abstracts the low-level data transfer protocol and presents a simple and highly efficient API for building a solution based on PXImc." You also have a picture showing the different fonctionnal calls of the API.

>>Introduction to PXImc - Technology for High Performance Test, Measurement & Control Applications

http://www.ni.com/white-paper/12523/en/#toc3

I will let you know if I find anything else.

Have a nice day.

Regards.