ECG Labview Simulation

[berper]

Hello, I'm writing because i can't run the ecg simulator that i've downloaded from http://zone.ni.com/devzone/cda/epd/p/id/6189#0requirements

When i try to use it,  it appears a box dialog that says "Find the VI named 'Configure Serial Port.vi'. I tried to open the VISA  Configure Serial Port.vi but i believe that number/type of the inputs and outputs of it, does not match to the expected by the program.

I would be grateful if you could send me some help.

Thanks in advance

[Coq_Rouge · Accepted solution]

I have a simulator for ECG. It is not made by me, but NI

How to install

1) quit Labview

2) Unzip to folder ............\National Instruments\LabVIEW 8.6\user.lib\_express (you find it in the program files folder)

3) start Labview

4) Se the picture for help on how to find it

[berper]

Thanks a lot Coq Rouge ! That was exactly what i was looking for! Sorry i didn't show up for so long, but i've been out of town...

[marp84]

how i i want make ecg signal not with ecg simulation toolkit?

[Dennis_Knutson]

What's wrong with using the posted VI? It does not require the full toolkit.

[M. Abdelkader.]

Dear ,

i downloded you VIs but it doesn't work, could you please inform me about the problem.

M. Abdelkader.

[Coq_Rouge]

which Labview version do you have? If you use Labview 2009 you must use the  ....National Instruments\LabVIEW 2009\user.lib\_express folder If you use a older labview version than 8.6 it will not work unless it is converted to the older version

[M. Abdelkader.]

I used Labview V 8.6 is there any ideas to solve this problem.

[Coq_Rouge]

You must tell me why it is not working;)

[M. Abdelkader.]

so sorry it just a warrning, thank you for your interest.

it's now working.