DIADEM Graph 3D

[MarcoM]

Help!

The aim is to load several signals on a preconfigured 3D graphs Diadem rapport.Concerning the Z-matrix, as the numbers of channels is variable I would like that the graph select automatically all the channel that are in a group.  Example:Signal 1X-Axis: Group 1 - Channel1Y-Axis: Group 2 - Channel 1Z-Matrix: Group 3: Channel 1 to Channel 10  Signal 2X-Axis: Group 1 - Channel1Y-Axis: Group 2 - Channel 1

Z-Matrix: Group 3: Channel 1 to Channel 16

Regards

Marco

[Marco_Brauner]

Hi Marco,

I don´t exactly get what you intend to achieve. Could you please explain a little bit more precisely what

the result should look like?

best regards

Marco Brauner NIG

[altenbach]

If this is not a LabVIEW question, I would recommend the Diadem forum for more specific help. Good luck!

[MarcoM]

I’d like to automatically print 3D graphs in a report.

I’m working with a Matrix structure (3D Axis definition-->Curve List-->Channels).

The number of channels to select in the z-matrix is variable (depending from the signal).

Then I’d like that the z-matrix contains all the channels that are in a certain group. 

Is it possible to define the z-matrix as

z-matrix: Group Name 

instead of

z-matrix: Channel Name to Channel Name  ? 

Hope it’s clear now

Thanks

Marco

Message Edited by MarcoM on 11-29-2008 03:34 PM

Message Edited by MarcoM on 11-29-2008 03:35 PM

[Marco_Brauner]

Hi, I don´t think this is possible without a script which selects the right Z-Channels, but you have to make sure

that the 3d-graph gets the right amount of Z-Channels then. But you can also just create a channel-group containing

X,Y and apropriate count of Z-Channels (exactly in this order) and drag the whole group to your 3D-graph. DIAdem then

takes the right channels automatically.

Hope this helps

regards

Marco