From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
Everything works somewhat fine... but sometimes when I stop the program and run it again the values does not change when I move the IMU. Can you think of any reason?
Arduino IDE work fine like expected.
When you stop the LabVIEW program without closing the serial port properly, the resource can get locked and you won't be able to read data without restarting LabVIEW. Check if you are doing the cleanup after execution properly when exiting the program.
Why is it that sometimes when I run LabVIEW it gets stuck with some data and when I try to move the IMU, the data does not change. Is it because my computer is slow or something?