LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Blockdiagram of a PID controller

Solved!
Go to solution

 

 

 

Inorder to work properly for the below attached pid controller frontpanel diagram what will be the blockdiagram????PLz help.

 

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Thanks as kudos only:)
0 Kudos
Message 1 of 6
(4,768 Views)

umm.. what? Are you asking us to write your code? Really?

 

Perhaps you should spend a little time doing some search on this site for PID controllers. Or perhaps you may want to look at http://sine.ni.com/nips/cds/view/p/lang/en/nid/209054

0 Kudos
Message 2 of 6
(4,742 Views)

I strongly suggest you to install the LabVIEW Control Design and Simulation Module (if you are academic, you probably have this already - talk to your System Administrator) and you should look into this "tutorial" below: 

 

http://zone.ni.com/devzone/cda/tut/p/id/6931

 

This should not be very difficult.

Barp - Control, Simulation, RTT and HIL - National Instruments
0 Kudos
Message 3 of 6
(4,731 Views)

Hello Barp,

                I went through the tutorial in the link suggested by you.But Iam confused how we will use our own transferfunction instead of H(S) in that block diagram.

 

Thanx.

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Thanks as kudos only:)
0 Kudos
Message 4 of 6
(4,699 Views)
Solution
Accepted by danil33

If you double-click on the Transfer Function block, you can select From "Terminal" or "Configuration". If you use Configuration, it will allow you to enter the information directly in the block with creating an external model.

 

I would strongly recommend also see those resources below:

http://home.hit.no/~hansha/documents/labview/training/Control%20and%20Simulation%20in%20LabVIEW/Cont...

http://multimechatronics.com/images/uploads/tutorial/LabVIEW%20SimulationTutorial.pdf

http://zone.ni.com/devzone/cda/tut/p/id/5855

 

Hope this helps.

Barp - Control, Simulation, RTT and HIL - National Instruments
Message 5 of 6
(4,661 Views)

thank USmiley Very Happy

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Thanks as kudos only:)
0 Kudos
Message 6 of 6
(4,641 Views)