Any Energy Meter with Labview

[Asif138]

Thanks for all replay,

Now i have received power meter Lovato DMG210 which have RS485 port. i test to read its holding register using modbus poll software. i am using RS485 to Ethernet converter (picture attached) i configure converter baud rate and other setting as power meter so became able to see data on modbus poll software.

now i want to read this meter data on LabView. i never used modbus in labview but just read some documents which shows LabView provide three types of modbus communication. as describe here:

https://www.ni.com/en-lb/innovations/white-papers/12/introduction-to-modbus-using-labview.html

as i am knew so i want to use easiest way to communicate with energy meter.

what method should i use for this.

Thanks

asif 

[Asif138 · Accepted solution]

Thanks every one for your support,

i finally configured LOVATO DMG-210 power meter using modbus liberary and succeed to read its register values.

thanks.

asif