Thanks to everybody that replyed last post! I agree with you, these sequences are overkill. But... this was just a simplified simulation. Real software is very sequentially programmed. There is no parallelism at all. One motor running at a time (due hardware restrictions)
task-> check status -> more tasks -> case... & so on...
I don't even know why we are using Labview... Anyway... nothing has changed this way yet.
This is a more simple question... and it's pointed with red "here!" so you don't get lost.
This "Speed 1 - Copy" graph behaves kinda like it should. Updates every time a mass is moved... But... 1) I can't initialize it. ? Constant I tryed is also pointed. 2) every parameter should have a different color. (See Speed 1 - FWD).
Ok Erick, give me a little bit of time and I'm gonna show you what I meant earlier by telling you to get things legible. The problem you have with your copy is that there is only one color because there is a single plot. I'm gonna also try to show what I meant. The initialisation has to be done in the first sequence of your VI.
Hope this helps ! You won't have to wait for more than 20 hours to have your new VI cooked.
Hi Erick, I worked a little bit on your VI in order to show you how to update your XY Graphs in each iteration of a loop. I made it a bit more legible, but didn't change anything in the way it worked. I also made a subVI that simulates a new speed, freq and current. I added differents graphs for Backward and there are really too much of them now...
I can't believe the work u had and time u spent with this VI! Sure u work for NI and your boss obligated u to help me! 🙂 Send me his email so I can tell him good things about u.
Merci... Je suis vraiment choqué... (I've been learning french for the last 2 minutes.. with the help of google translator) Merci... over and over again.
Sorry, U have no luck at all... you just helped a trainee (wich is the lowest ranked position ever!) 🙂 Anyway, I'm working in Dortmund until end of August ( I come from Brazil). So if u need anything or have any interest in Germany, please send me an email: brenner@elliptec.com
