How to stop and send a message ?

[RayJz92]

I want to stop the program and send a message if the "fwd amp" or "rev amp" indicators show "2.3"~ or more, any suggestions ?

[Nathan_B.]

This is how to stop the loop if either of the voltages is greater than 2.3V and then show a message.

It will only show the message if the loop stopped by one of the two voltages and not when you hit the stop button.

EDIT:  I noticed that I used the wrong voltage for the conditionals but you can obviously change that to your desired value.

[RayJz92]

thanks, i will test it in some hours, ill post the results.

edit:

It worked, also, i searched a little bit and I did it with a state structure "machine"

if the amps are bigger than the set point, I stop the motor from working and I display a message asking for a password to continue.

herespart of the VI

thanks

[VisKat]

I replied to wrong message. Apologies. 

[VisKat]

I replied to wrong message. Apologies.