Easily Load LIFA Using HEX

[paulo33]

Thanks you very much, that all that I needed

[arjun1234]

hey, can i get the same for arduino with atmega8.Or could you tell me how to modify it for atmega 8?

Thanks!

[Hooovahh]

The binary attached is made only for the Uno, or the Mega 2560.  Start a new thread if you have a question not related to uploading the posted binary to one of those two devices.

[psrathaur]

hi friends thanks for sharing your r&d can you who send me whole procedure of interfacing the ardunio with labview

[Nathan_B.]

You can now interface between LabVIEW and Arduino using LINX (LIFA is no longer officially supported).  Check out the LINX website:  http://www.labviewhacker.com/linx

[rangi]

hi brian,

could you tell me how to create a hex file. i'm using arduino uno.

[Nathan_B.]

You should use LINX.  It's got everything compile already and even has a utility to upload it to your Arduino for you!

http://www.labviewmakerhub.com/linx

[Hooovahh]

I too suggest looking into LINX, but there is nothing currently wrong with LIFA, so do as you please knowing you'll get more support for LINX.  What I did was I used the Arduino IDE and compiled just like normal.  During the compile process a HEX file is created before it is uploaded to your hardware.  I looked up where this file is saved and found its temporary location, then just copied away the file and included it in my first post.  You could do the same for LINX for any compatible Arduino hardware, but LINX has a firmware uploading tool which aims to making this step easier.